QDI PlatiniX 2E/333, Manual

Page: 11 / 79

8
QDI
Installation Instruction
Hard Disk LED Connector (HD_LED)
The connector connects to the case’s IDE indicator LED indicating the activity status of IDE
hard disk. The connector has an orientation. If one way doesn’t work, try the other way.
Reset Switch (RESET)
The connector connects to the case’s reset switch. Press the switch once, the system
resets.
ATX 12V Power Supply Connector & Power Switch (POWER SW)
The power switch (POWER SW) should be connected to a momentary switch. When powering
up your system, first turn on the mechanical switch of the power supply (if one is provided),
then push once the power switch. When powering off the system, you needn’t turn off the
mechanical switch, just push once the power switch. P2E/333 series mainboard only support
ATX12V power.
I f you change “Soft-off by PWR-BTTN” from default “Instant-off”
to “Delay 4 Sec” in the “POWER MANAGEMENT SETUP” sec-
tion of the BIOS, the power switch should be pressed for morethan
4 seconds before the system powers down.
POWER SW
12V
12V
GND
GND
+12V Power Supply Connector
ATX Power Supply Connector
12V 5VSB 5V GND 3.3V GND 5V GND PS-OK 3.3V
5V 5V -5V GND PS-ON -12V 3.3V GND GND GND
1
Note:
All manuals and user guides at all-guides.com