QDI PlatiniX 1, Manual

Page: 13 / 73

Manual for PlatiniX 1
ATX12V Power Supply Connector & Power Switch (POWER SW)
Be sure to connect the power supply plug to this connector in its proper orientation. The
power switch (POWER SW) should be connected to a momentary switch. When powering
up your system, first turn on the mechanical switch of the power supply (if one is provided),
then push once the power switch. When powering off the system, you needn’t turn off the
mechanical switch, just Push once
*
the power switch. The difference between ATX12V
power and ATX power is ATX12V power added two power connectors:AUX power con-
nector and +12V power connector. PlatiniX 1 series mainboard only support ATX12V
power.
Note: If you change “Soft-off by PWR-BTTN” from default “Instant-off” to “De-
lay 4 Sec” in the “POWER MANAGEMENT SETUP” section of the BIOS, the power
switch should be pressed for morethan 4 seconds before the system powers
down.
Hard Disk LED Connector (HD_LED)
The connector connects to the case’s IDE indicator LED indicating the activity status of IDE
hard disk. The connector has an orientation. If one way doesn’t work, try the other way.
Reset Switch (RESET)
The connector connects to the case’s reset switch. Press the switch once, the system
resets.
Chapter 2
POWER SW
ATX Power Supply Connector
5V 5 V -5V GND GND PS-ON -12V 3.3V GND
12V
5VSB 5V GND
3.3V
GND
5V GND
PS-OK
3.3V
GND
12V 12V
GND GND
+12V Power
Supply Connector
GND
3.3V 3.3V GND GND 5V
AUX Power Supply Connector