QT-5000 & Remote Control Audio System
Revision: 6
QT-5000 and RCAS User Manual v6.docx
Page 9 of 30
Q5X Systems, Inc. 2012
The QT-5000 Transmitter
Out-of-the-Box Setup
Ensure the QT-5000 is sufficiently charged by immediately inserting the charger.
Using the Reset Key after Charge
Earlier hardware revisions of the QT-5000 had an issue where the unit would occasionally need to be
reset after being connected to a charger.
It is recommended that each time the charger is disconnected from the QT-5000, the Reset Key (which is
attached to the cable of the charger) should be inserted into the charge port, held for 1 second, and
then removed.
After the Reset Key is removed, the Status LED will blink green 3 times.
Charge LED Colour
When connected to a charger, the colour of the Charge LED will indicate the progress of the charging
cycle. The LED is located on the front of the transmitter.
Note: After the LED changes from Amber to Green, it is recommended it be charged for 15
more minutes while the trickle charge completes.
GREEN
– The battery is charged and ready for use.
AMBER
– The battery level low, but can be used for short term use, such as setup or quick
audio tests.
RED
– The battery level is unusable and must be charged.
