Q Imaging Rolera EM-C2, User Manual, Page: 8 / 22

Step 2. Install Your Imaging Software
Once the IEEE 1394 card is installed in your computer, you are ready to install the FireWire drivers and
imaging software. See your Imaging Software User’s Guide for complete installation instructions.
Step 3. Connect the Rolera EM-C
2
Once your imaging software is installed, connect your camera. For the Rolera EM-C
2
, in order to
operate the cooling, the camera must have the external power connected. However, should the
cooling not be required, a single 9-pin to 9-pin connection will operate the camera sufficiently.
In most cases, the FireWire cable provides the necessary power required by the Rolera EM-C
2
.
However, if your camera is cooled you will need to provide additional power to the camera as shown
in Figure 5.
Connecting the QImaging Camera
Perform the following for connecting your camera.
• Remove the FireWire cable from the camera box, and plug one end of the cable into the
camera’s FireWire socket.
Figure 3 — Camera FireWire Socket.
5