Q Acoustics 3060S, Owner'S Manual

Page: 14 / 208

14 15
ENGLISH (EN)
Setting Up
Check that all system connections are properly and securely made. Ensure that the subwoofer is
switched off. Set the controls to the following default settings:
Level Approximately half
Crossover Minimum (50Hz) for large floorstanders and halfway (100Hz) for
bookshelf or small speakers
Phase invert 0°
Auto on AUTO or ON
Plug the supplied power cord into the subwoofer and then into the AC supply socket. Switch on
the power at the supply socket and then switch the power switch on the subwoofer to ‘ON’. The
POWER light on the subwoofer amplifier panel will glow and the subwoofer is operational.
Play some music you are familiar with and experiment with the Phase invert setting and level
control until you hear a good blend between the front speakers and the subwoofer. If you can hear
the subwoofer standing out it’s too loud!
Always bear in mind that the human ear’s sensitivity to bass varies enormously with the volume
level, hence the need for a wide range of programme material and sound levels. Once you are
happy with the sound you can then fine tune the performance by using the remaining controls.
Crossover: The crossover control determines at what frequency your subwoofer output begins to
rapidly diminish. This should be set so that it corresponds with the frequency your main speakers
begin to produce a strong output by themselves. The adjustment allows for a smooth handing
over between subwoofer and main speaker output. If this setting is too low there will be a ‘hole’
in the sound where certain frequencies are weak, conversely if it is too high there will be an
exaggeration of certain frequencies producing an overpowering bass. You can get an idea of
the correct setting from your main speakers specification sheet, look for the lowest frequency
that the speaker produces (the “-3dB point”) under the “Frequency response” heading. Room
positioning has a dramatic effect on low frequency reproduction of both the subwoofer and your
main speakers so don’t be worried if you find you require a setting which does not correlate with
the specified low frequency point of your main speakers.
Stereo System