22
© 1999 Directed Electronics, Inc. Vista, CA
This system usually requires a negative pulse to unlock, and cutting the wire to lock the door. In some vehicles,
these are reversed. It is found in late-model Nissan Sentras, some Nissan 240SX, and Nissan 300ZX 1992 and later.
It is also found in some Mazda MPV's and some Mitsubishi's.
One relay (optional) is used to interface to this type of system as follows:
plug-in harnesses
The super bright LED operates at 2V DC. Make sure the LED wires are not shorted to ground as the LED will be
damaged. Multiple LED’s can be used, but they must be wired in series. The LED fits into a 9/32-inch mounting
hole. Be sure to check for clearance prior to drilling the mounting hole.
The Valet®/Program switch should be accessible from the driver’s seat. It plugs into the blue port on the side of
the unit. Since the system features Valet® by using the remote transmitter, the switch can be well hidden.
Consider how the switch will be used before choosing a mounting location. Check for rear clearance before drilling
a 9/32-inch hole and mounting the switch.The GRAY wire in the two-pin plug may also be used as a (+) ghost
switch input and can be connected to any (+) switch in the vehicle. (See
Feature Descriptions
section of this
guide.)
valet/program switch, 2-pin blue plug
super-bright LED, 2-pin white plug
type F: one-wire system
Summary of Contents for 1000 ESP
Page 1: ...1999 Directed Electronics Inc Vista CA N439 12 99 1000 ESP Installation Guide...
Page 39: ......
Page 40: ......