PSI System Controls and Diagnostics
F3200E User Manual
F3200E_UM_180726 Page 17 of 107
Local buffering
Up to 65535 points each of 32 channels in buffered mode.
Up to 1000 points each 32 channels in sweep mode.
Acquisition modes
Internal (free running and continuous transfer to host)
Buffered mode (on-board buffering of contiguous blocks of
readings).
Sweep mode (on-board buffering of triggered acquisitions,
averaging across multiple sweeps for repetitive signals).
External gate input
0 / +5 V (TTL level), 10 kohm input impedance.
External gate output
TTL levels, 120 mA maximum current.
Analog outputs
Three general purpose, +/-10V, 10 mA compliance. 16 bit
resolution, low transition glitch energy. Maximum update rate
250 kHz.
Analog monitor output
Analog output 1 can be assigned to monitor function.
Analog inputs
Four general purpose, differential, two-pole analog low pass filter
17 kHz. 16 bit resolution, maximum conversion rate 400 kHz
(downsampled to 10 kHz maximum).
Digital outputs
Four general purpose, TTL levels, 5 mA typical, 35 mA
maximum (single output)
Digital inputs
Four general purpose, TTL levels. 50 kohm pull up to +5VD.
Auxiliary HV PSU (option)
0 to 2000 V / 1000 V / 500V / 200V programmable, 1W max
output power.
Noise and ripple <0.1% of full scale.
Actuator I/O
Two opto-coupled inputs (24 VDC nominal) for limit switch
readback, one +24 V relay-switched output for actuator solenoid,
one +5 VDC relay-switched test output for general purpose.
Test output
+5 VDC also available on signal inputs for remote test resistor
arrays.
Power input
+24 VDC (+/-2 V), 750 mA (excluding current supplied to
actuator solenoid).
Communications interfaces
Ethernet 10/100 Base T, TCP/IP and UDP.
RS-232 / RS-485 115.2kbps, binary serial protocol.
Fiber optic 10 Mb/s binary serial proprietary protocol.
Controls
Two rotary switches for loop address and communications mode.
