System Installation
3.1
Installation key points
The product is specially designed for 12V vehicle, if installed in other vehicles, please
install power Changer.
To avoid short-circuit, it is strongly suggested to disconnect accumulator cathode before
installation.
This product should not be used without fuse.
Do not connect with the mains directly with that of other electrical equipments.
Do connect the ACC & BATT cord according to the installation instruction, or the
instrument will automatically power off abnormally. And please remember to switch off
the power supply after usage, or it will consume lot of the stored battery.
The installation position should be chose in a place which will not effect the
Operation of other electronic instruments, such as air-conditioner.
3.2 Host equipment installation
Pay attention not to destroy or dirty instrument desk.
Find a free slot in the instrument desk, clean up the inside for enough space.
insert DVD player in the slot.
Take out the host equipment and connect to power supply jack, video jack.
Please refer to CD changer installation instruction.(Refer to 11.2)
3.3Connection
Connect power cord ACC (red) to ignition switch.
Connect BATT (yellow) to the circuit of accumulator.
Connect back running cable (blue) to back running switch or back running lamp
Circuit (12V is valid)
Connect antenna and amplifier control cable.
Connect all video cable to video inputs.
Connect speakers to amplifier outputs (pay attention to color and polarity)
Plug antenna-to-antenna jack.
Connect CD changer control line (referring to CD changer installation)
Check all connections.
Clean up all cables for installation
-4-
