5.4 Time setting
Press SET to go into System Setup (refer to 5.3.3 in detail),
and select TIME ADJ, press (18) vertically to confirm
entering into time setup mode. The screen will display as the
right picture.
Press or (18) for time adjusting, press or (18) for change-over selection between
HOUR and MINUTE. Press vertically after that to confirm and store the time setup,
also return to System Setup.
Press SET directly to exit without storing the setup.
Or (18) to make setup. Press SET again to exit System
Note:
When the blue screen is set to
ON
, and no visual signal is input, the
screen will display in blue.
TIME
12:00
ADJ
5.5 Monitor angle adjust
When the system is
ON
, short pressing can adjust the display angle to the
preset angle or return to vertical mode.
A.When the system is under non-DVD mode, the display angle status can be
vertical
preset angle;
B.When the system is under DVD mode, the display angle status can be vertical
preset angle
max. angle.
When the system is
ON
, pressing on the remote board can tune the
display angel to bigger or smaller;
The preset angle of the display can be set in the System Menu (refer to 5.3.1),
under non-DVD mode, or also can be used to preset angle.
Radio operation
6.1 Receive pre-stored stations
Press RADIO to enter into radio mode
and play back the pre-stored radio channels,
please see the right picture.
Press
or to play the pre-stored last or
next radio channel;
FM - - M 2
M1
M2
M3 M4 M5 M6 M7 M8
M1 M2 M3 M4 M5 M6 M7 M8
RADIO
90.6
MHz
FM - - M 2
