3.1.6 Adjust the LOWER STEM (12) so that when you stand upright with the detector in
your hand, the SEARCH COIL (14) is level and about 1/2 to 2 inches above the ground
with your arm relaxed at your side.
3.1.7 Tighten the STEM LOCK NUT (8) in the reverse direction (counterclockwise) to lock
it in place.
3.1.8 Loosen the SEARCH COIL KNOBS (13) at the SEARCH COIL ASSEMBLY (14).
Then, adjust the search coil to the desired angle. (The Search Coil should be parallel with
the ground). Tighten the knobs just enough to keep the search coil from rotating or
wobbling.
3.1.9 Loosen the screws at the bottom of the ARMREST. Adjust the armrest so that it
should be near to the end of your forearm. Re-tighten the screws.
3.2 INSTALLING BATTERIES
You need 6x 1.5V AA alkaline batteries to power your detector.
3.2. Press the POWER button on the control panel to make sure that the detector is OFF.
3.2. Turn the Disc dial counter-clockwise to the OFF position to make sure that the
detector is OFF.
3.2.2 Slide the battery cover away from the BATTERY COMPARTMENT (9).
Summary of Contents for PHMD53
Page 1: ......
