The controller is equipped with 4 indicator lights:
9.4. Indication lights
37
Indicator light
Function
DATA
d
ata collection
;
Ÿ
w
hen data packets are collected from the PC or
smartphone application - the indicator light flashes
INPUTS
d
igital inputs state
;
Ÿ
e
ach short-circuit of one of the inputs causes the light
to flash
DMX
DMX output state
;
Ÿ
w
hen the DMX signal is sent, the indicator light flashes
POWER
d
evice state
;
Ÿ
w
hen the device is turned on and runs in normal mode
- the indicator light in on permanently
,
Ÿ
w
hen the device is turned on and off in the core mode -
light flashes quickly (the DMX light does not flash)
Ÿ
w
hen the device is in normal mode but there is no
preloaded configuration - the light flashes slowly (the
DMX light flashes as well)
Ÿ
i
f the main controller is unable to establish connection
along the CAN bus with all the expansion modules
which have been configured, the indicator light blinks
slowly (and the DMX indicator light blinks at the same
time).
When you are starting or restarting a system incorporating a PX710M main controller and
PX710S expansion modules, the main controller tries to establish connection along the CAN bus
with the expansion modules. In this case, the
DATA,
INPUTS, DMX indicator diodes blink
simultaneously. If the controller establishes connection, it will go on to operate normally. If it fails,
it will behave as if no configuration had been uploaded into it.
