5. DATA SENDING MODE
6. CONTROLLER OPERATION MODES
The Club 6p controller has 3 modes of data sending to the DMX line. In all modes the controller
sends out the data to the first 24 DMX channels.
A MODE
- the first 6 channels are for the sliders, taking the sum slider into consideration, the
remaining 18 channels are always zero.
B MODE
- the controller sends out 4 identical packets, 6 channels each. The channels value
corresponds with the sliders adjustments, considering the sum slider.
C MODE
- the first 6 channels correspond with the sliders, considering the sum slider, the next 6
channels do not take sum value into consideration, the remaining 12 are always zero.
To select the data sending mode:
1. Turn the controller off.
2. Press and hold the K1 button.
3. Turn the controller on.
4. After approximately 3 seconds release the K1 button.
5. You have programmed the A MODE.
6
Club 6p controller can operate in two modes: standard and programmable. By pressing the
MEMORY key you can switch between these two modes.
The B and C modes programming is performed with the, accordingly, K2 and K3 buttons. The
mode change is permanent, that means, cutting off the power supply and turning on again without
holding K1, K2 or K3 button does not affect the previously selected mode.
After switching the controller on, the data sending mode is indicated with a LED flash in the
appropriate K1, K2 or K3 button.
K1
K1
K1
3 s
6.1. STANDARD MODE
After turning on, the controller sets itself automatically in a standard operation mode. The value
on the output of each channel is dependent on the corresponding slider adjustment and the
MASTER slider position. By pressing the FLASH key the channel lights up at 100%, regardless of
the sliders position.
Memory
The LED over the MEMORY button is
dimmed.
LEDs 1-6 indicate the 1 - 6 sliders status.
K7 - K10 keys are inactive.
