Nixie Tube Clock ‘Dink’
Issue 9 (10 November 2017)
www.pvelectronics.co.uk
- 12 -
Resistors R1-R3, indeed all the resistors on the board need to be
mounted upright to save space. The leads need to be formed as
shown below. Bend the leads of each resistor as shown and solder
in to the correct postion, making sure the component body is as
close to the board as possible.
After installation of step 4.3 components, this is how the PCB
should look:
If your kit contains the radial inductor, use a short piece of wire to
extend one lead of the inductor as shown below:
