AWS1100 Wet Sander Manual 4
Copyright PushCorp, Inc. 2000. All rights reserved.
3.0 Installation
3.1 Mounting the AWS1100
The AWS1100 Wet Sander attaches to the robot’s mounting flange. The Wet Sander
is supplied with a removable Mounting Plate. PushCorp, Inc. can provide the
Mounting Plate blank, or with a customer specified bolt-hole pattern.
A minimum of three flat-head screws (user supplied) is required to securely attach the
Mounting Plate to the robot’s mounting flange. These flat-head screws must be
installed per the robot manufacturer's instructions.
To mount an AWS1100 first remove the (4) four M8 fasteners that secure the
Mounting Plate to the Base. The Mounting Plate is attached to the robot, with the
user supplied flat-head fasteners. Then align the AWS1100 Base with the Mounting
Plate, and re-install the (4) four M8 fasteners. Torque the M8 fasteners to the value
listed in Section 6.0.
Mounting Plate
M8 Fastener
Base
Figure 1. AWS1100 Mounting Scheme