PURSUIT SC 365i, Owner'S Manual

Page: 24 / 146

2-4
Section 2 Helm Systems
SC 365i
2.7 Automatic Fire Extinguisher
System (with Generator)
This system protects the machinery space in
the case of fire. The helm mounted display
provides systems status - charged (visual),
discharged (visual and audible) -and an
override switch to allow for engine restart.
Generator blower operation is required after
the fire suppression system discharges. To
operate blower reset the system. Run the
blower for four minutes before opening gen-
erator compartment to evacuate the fire sup-
pression agent.
For additional important information on this
system, read Automatic Fire Extinguishing
System in the Safety Equipment and the
automatic fire extinguisher owner's manual
in the Generator Compartment of this
binder.
Automatic Fire Extinguisher Display Unit
2.8 Steering System
The steering system is hydraulic and made
of two main components: the helm assembly
and the hydraulic cylinder. The helm unit
acts as both a fluid reservoir and pump.
Turning of the helm, or steering wheel,
pumps the fluid in the hydraulic hoses and
activates the hydraulic cylinder causing the
motors to turn. A slight clicking sound may
be heard as the wheel is turned. This sound
is the opening and closing of valves in the
helm unit and is normal. Refer to the steer-
ing manufacturer owner’s manual for spe-
cific information on the steering system.
Dual engine outboards are coupled at the til-
ler arms by a tie bar. The outboards must be
aligned with each other to provide maximum
stability on straight ahead runs and proper
tracking through corners. If damage has
ever occurred with the outboards or steering
system, the outboards may have to be
realigned.
Power Steering
The power steering system uses an electri-
cally controlled hydraulic pump to provide
power to the standard hydraulic steering
system. Additional components are a helm
mounted power steering switch and a
hydraulic pump. The switch activates the
power steering feature. Manual steering is
always available regardless of the switch
position. To reduce the sensitivity of the
steering, turn off the power steering at low
speeds. To conserve battery power, because
of limited engine charging output, during
extended periods of slow speed operation,
the power steering should be turned off.
Refer to the Teleflex® Power Assist manual
for more information.
Yamaha Helm Master
The Yamaha Helm Master system is
optional. Refer to the Yamaha Owner's Man-
ual for operational information.
Tilt Helm
A tilt helm, steering wheel may be installed
on your boat. To tilt the helm, depress the
lever located in the base of the helm and
lock into position. DO NOT adjust when the
boat is underway.
!
CAUTION
Some autopilot systems have engine
position sensors mounted to the
hydraulic steering cylinder. The sen-
sor bracket can contact the transom
when the engines are fully tilted up
and damage the autopilot, engine rig-
ging or transom. Monitor the bracket
and rigging while engines are tilting to
determine the best position for your
application.