PURSUIT 2270 CENTER CONSOLE, Owner'S Manual

Page: 77 / 104

2270 CENTER CONSOLE
Chapter 11:
SEASONAL MAINTENANCE
11.1 Lay-up and Storage
Before Storing
•
Pump out the head. Flush the holding tank using clean soap, water and a deodorizer. Pump
out the cleaning solution.
• If your boat is equipped with a portable marine head with a pump out, it must be pumped prior
to lay-up. Flush the holding tank using clean soap, water and a deodorizer. Pump out the
cleaning solution.
• The fuel tank should be left nearly full to reduce condensation that can accumulate in the fuel
tank. Allow enough room in the tank for the fuel to expand without leaking out the vent.
Moisture from condensation in the fuel tank can reach such concentrations that it becomes
heavy enough to settle out of the gasoline to the bottom of the tank. Since fuel pickup tubes
are located near the bottom of the tank, this accumulated moisture can cause the engine to run
poorly or not at all after extended storage.
Chemical changes also occur as the gasoline ages that can cause deposits and varnish in the fuel
system as well as reduce the octane rating of the fuel. Severely degraded fuel can damage the
engine and boat fuel tank and lines.
Therefore, if your boat is not being run enough to require at least one full tank of fresh fuel a
month or during winter storage, a fuel stabilizer should be added to the gasoline to help protect
the fuel system from these problems. Operate the boat for at least 15 minutes after adding the
stabilizer to allow the treated fuel to reach the engine.
Your dealer or the engine manufacturer can provide additional information on fuel degradation
and fuel stabilizers recommended for your engine. For more recommendations for your
specific area, check with your local Pursuit dealer.
• Drain water from the freshwater system.
• Consult the engine owner’s manual for detailed information on preparing the engine for
storage.
11-1