Purmo TempCo Central, User Manual

Page: 31 / 266

31
Ambient sensor calibration:
- To check the temperature in the room, put a thermometer at 1.5M
distance to the floor in the concerned room and wait 1 hour to be
sure that the thermometer show the correct temperature.
Then you can enter the value saw on the thermometer with
(
◄-)
or
(►+) in the corresponding line “
Ambient
” and press
(Ok) to valid.
- When a
calibration is made the message “
Made
” will be
displayed.
- To erase the calibration already made press
(Ok) and change the
value “
made
” by “
no
” with
(
◄-)
or
(►+)
.
External sensor calibration:
- The calibration must be done same as described above if the
external sensor is connected and used like a deported ambiance
sensor.
- If the external sensor is used as floor sensor, the thermometer
should be put on the floor.
4.3.4 Pump Exercise
Anti-lock-braking function of the pump and actuators. When the
pump or actuators hasn’t worked during more than one day, the
output will be switch on for one minute to avoid stuck problem.
To active this function, move the navigation cursor in front of the
desired line and Press
(Ok)
to valid “

”.
4.3.5 Units Am / Pm...
On this menu you could choose the units will be displayed.
Installation
Regulation Sensor
Regulation type
Calibration sensor

Pump exercise

Units AM/PM...
Units Am / Pm...
24h °C 12h °F