6
FCIR HEATING ELEMENT
User manual
Figuresse Control IR • 2021-01-01
GB
DE
NL
temperature regulation
dryer On/Off switch
IR sensor
Turning the device on with the button will result in the
radiator heating up to the set temperature. After reaching
the set temperature the device will turn off and on regularly
in order to maintain the set temperature.
The construction of the device as well as the physical char-
acteristics of the heating agent inside the radiator, influence
the way in which the heat is distributed — the temperature
of the bottom pipes on the radiator (especially the two lo-
cated at the very bottom of the radiator), may be lower than
the temperature of the remaining parts of the radiator — this
is a normal phenomenon.
TEMPERATURE INCREASE
In order to increase the temperature of the radiator, press
once or several times as required; the correct number of
diodes will start blinking. The last blinking diode indicates
the set temperature, whilst the last diode which shines
constantly, indicates the current temperature. The remaining
diodes will start shining constantly on reaching subsequent
temperature levels.
TEMPERATURE DECREASE
In order to decrease the temperature of the radiator, press
once or several times as required; the correct number
of diodes will start blinking. The last diode, which shines
continuously, indicates the set temperature whilst the
last blinking diode indicates the current temperature. The
remaining diodes will start fading on reaching subsequent
temperature levels.
ANTI-FREEZE FUNCTION
When the device is off and the temperature surrounding
the temperature sensor drops to below 6° C, the device will
switch on automatically. This is to prevent the heating agent
inside the radiator from freezing. The activation of Anti-
freeze mode is indicated by the blinking of the middle diode.
DRYER FUNCTION
The Dryer turns the device on for 2 hours, e.g. in order to dry a
towel. After this period of time the device automatically switches
to the mode to which it was set before the dryer mode.
In order to activate the dryer mode, press and hold the
button (also when the heating element is off) – the device
will start working and maintain the most recent temper-
ature setting. You can now freely adjust desired temperature
level (buttons und ). After 2 hrs heater will revert to the
previous setting (before dryer function activation).
To use 2 hrs timer heating element must be switched off.
Switch it on by pressing and holding button. After 2 hrs
heater will switch off automatically.
Press button at any time to interrupt the dryer mode.
REMOTE CONTROL MODE
(WIRELESS COMMUNICATION)
If the device is located in a room with an external IR control-
ler suitable for communication with the heating element, the
first signal received by the heating element will automati-
cally activate the reception mode. The device will maintain
the temperature indicated by the external controller while
continuing to limit the radiator temperature so that it does
not exceed 60°C. The remote control mode is indicated by
the middle diode. In case of communication loss longer than
25 minutes, the device will automatically switch back to
the manual mode, and continue to operate according to the
most recent setting. Any new signal received by the heating
element, will switch it back to the remote control mode.
The dryer function can be activated in the remote control
mode (when the dryer function is deactivated, the heat-
ing element will resume the reception of signals from the
external controller).
USE
