Puricom 970213, User Manual

Page: 22 / 64

Español
English
10
3. If the jar is removed from the unit to drink some water, the
process will stop the timer the moment it is stopped. When the
jar is returned to the base and the touch panel is pressed, the
process resumes operation at the same moment by emitting
a beep sound.
4. When the hydrogenation process has been completed, the
equipment will emit a BEEP sound and the display will show
‘0’. Water will be ready to be served. Still, the equipment will
keep a small residual flow for ten hours to delay the loss of
hydrogen in water. It is recommended to drink treated water
within 1 hour. Otherwise, keep hydrogen-rich water at room
temperature or in the fridge, inside an airtight container, thus
reducing the free space inside it in order to keep the concen-
tration of hydrogen solved in water. When you want to use the
equipment again, renew the water. Its colour and taste may
vary if water is hydrogenated without renewing it for a long
time.
9. MAINTENANCE AND CLEANING
• Clean the inside of the jar with tap water (do not use hot
water) and soap with the appropriate frequency, as you
would with a normal jar or dinnerware.
WARNING: Do not wash the jar in the dishwasher.
• If the jar is not going to be used for more than a week,
empty it and unplug it from the power supply.
If the jar has not been used for more than a week, empty it
and rinse it with tap water before using it.
If the jar has not been used for more than three weeks,
empty it and wash it with cold tap water and soap.
• Self-cleaning: By activating the self-cleaning cycle
(CL) after filling the jar, as described in the previous
section, the polarity of the electrodes of the electrolytic
cell is inverted to reduce possible build-up in them.
WARNING: During this cycle, Ozone will be ge-
nerated inside the jar and water must not be drunk
during this period. Dispose of this water before acti-
vating a normal hydrogenation treatment cycle.
WARNING: Water treatment with a hardness higher
than 15ºHF will reduce the service life of the essential
components of the equipment. In such case, it is recom-
mended to carry out at least 2 self-cleaning cycles per
week.
• Anti-scaling: Dissolve 5g of citric acid in 0.5l of water.
Once it has been completely dissolved, pour this volume
of water inside the jar and activate a self-cleaning cycle.
Dispose of water and rinse the jar with plenty tap water
after finishing the cycle.
• To replace the deozonator filter, open the plug from
the handle and place the deozonator filter (the filter
must be replaced every 9-12 months of use).
WARNING: The average service life of certain
components of the equipment may be reduced if
water to be treated is not softened or chlorinated,
or has a TDS higher than 300 ppm.
To remove the water residues from the ozone blee-
der, take out the deozonator filter and tilt the jar to
empty water.
Recommended maintenance*:
FREQUENCY
1x WEEK
2x WEEK
HALF-YEARLY/YEARLY
ANNUAL
HALF-YEARLY/YEARLY
*In function of water characteristics.
ACTION
Self-cleaning cycle (hardness <15ºHF)
Self-cleaning cycle (hardness >15ºHF)
Anti-scaling.
Replace the deozonator filter.
Replace the softening filter.