Gas Fired Tandoor Instruction Manual
Manual Rev. October 2019
Page | 13
DO NOT OVERTIGHTEN THE CONNECTION VALVE
The tip of the thermocouple should be 1” (25 mm) from the edge of the main burner
and level with the top of main burner.
The pilot flame should completely envelope the tip of the thermocouple.
7.2.
Ignite Electrode
1.
Remove the igniter lead from piezo.
2.
Undo the nut holding the light assembly cradle and withdraw.
3.
Replace the electrode.
4.
Replace as above in reverse order.
7.3.
Pilot Burner
1.
Loosen the thermocouple and pilot gas supply connection to the valve.
2.
Undo the nut holding the pilot light assembly cradle/bracket and replace.
7.4.
Gas Tap Assembly
1.
Loosen and remove connections to burner pipe and gas inlet pipe
2.
Loosen and remove connections to pilot burner.
3.
Loosen connection to thermocouple and remove.
4.
Loosen and remove the holding plate nut
5.
Withdraw tap/valve assembly
6.
Replace as above in reverse order
7.5.
Burner
1.
Remove rocks and plate sitting on the burner.
2.
Loosen connection from burner pipe to gas tap/valve and remove.
3.
Withdraw burner through top of oven.
4.
Replace as above in reverse order.
7.6.
Injector/Orifice Spud
1.
Loosen connection from burner pipe to gas tap/valve and remove.
2.
Loosen and remove injector/orifice spud carrier from burner.
3.
Loosen and remove injector/orifice spud from injector carrier.
4.
If necessary clean out injector with fine wire or air hose.
5.
Replace as above in reverse order.
