PureTools PT-PSW-41H, User Manual

Page: 14 / 28

User Manual
9
" XXXXXXX " is display control command
(ASCII, max 48 byte).
/+ax:0123456

Configure OFF button:
Command Format Description & Example Feedback
/-Ax:XX XX XX XX
"x" represents the baud rate: x=0(2400)/
1(4800)/ 2(9600)/ 3(19200)/ 4(38400)/
5(57600)/ 6(115200).
" XX XX XX XX " is display control command
(HEX, max 48 byte).
For example: /-ax:30 31 32 33
XX XX XX XX
(30 31 32 33)
/-Ax:XXXXXXX
"x" represents the baud rate: x=0(2400)/
1(4800)/ 2(9600)/ 3(19200)/ 4(38400)/
5(57600)/ 6(115200).
" XXXXXXX " is display control command
(ASCII, max 48 byte).
/+ax:0123456
XXXXXXX
(0123456)
d) Disconnect the control PC, then connect the display to the RS232 port.
e) Press ON or OFF button to turn the display on or off.
2) IR Learning
a)
Press the IR LEARNING button to enable IR learning mode, the ON and OFF LEDs will
light up.
b)
Press one of the display control buttons, e.g. press ON button, and its LED will start to
flash.
c)
Point the display remote at the front panel built-in IR receiver and the press the Power
On button on the remote, and the ON LEDs will go dark.
d) Repeat the above all three steps to set the OFF button function.
e) Press ON or OFF button to turn the display on or off.