PureLink
VIP-200 II Quick Start Guide V1.0
9
Troubleshooting – Point-to-Many
Receiver cannot find transmitter
•
Receiver is not set to correct channel for transmitter
•
Receiver or Transmitter are not connected via CAT cable or via network switch
•
Power to transmitter is off
•
Power to network switch is off
Transmitter reports no source (via OSD on Receiver lower left corner)
•
Check source is active
•
Ensure input cable is plugged in to correct port on transmitter (input vs loop out)
•
Confirm cable passes signal and is not damaged
•
Check power to transmitter is on
Appendix
Methods to determine Auto IP assignments
There are two ways to determine the IP assignments of the transmitters and receivers.
1.
On Screen Display
Once the receiver discovers the transmitter that equals the channel it is assigned to, it will
display both IP addresses in the lower right corner when no video signal is present. If
a video signal is present, you can request display of the host (transmitter) and client
(receiver) with the following remote-control buttons:
2.
Network Discovery
This method is available only when the transmitter(s) and receiver(s) are connected via a
network switch, and a computer running the iCON VIP Device Manager discovery tool is
utilized. The computer’s ip4v address must be set correctly to detect the devices.
