PureLink
VIP-200 II Quick Start Guide V1.0
5
One Transmitter to Multiple Receiver Setup (point-to-many distribution)
Point-to-many connection via CAT5e or better cable (Auto IP mode and CAT6a cable recommended)
VIP200 II transmitters and receivers ship in Auto IP mode, which allows them to discover each other
with no configuration required. While it is possible to reconfigure the transmitter and receiver to
Manual IP or DHCP IP mode, there is no value to making these changes in a point-to-many
configuration, unless you need them to be on an existing network
•
Connect the transmitter to your network switch
•
Connect your receivers to the network switch
•
Connect your source to the input of your transmitter
•
Connect a display to the output of each receiver
•
If desired, connect your confidence monitor to the loop out of the transmitter
•
Connect the power adapters for each unit and apply power. The system will go through a normal
boot up sequence that takes approximately ten seconds to display the image.
Transmitter
Receiver
Receiver
Receiver
Network Switch
Example Application – One-to-Many
