SMC4-4-16A16B.
Four-axis motion controller
Edition of 03.08.2016
22
www.purelogic.ru
8 (800) 555 63 74
Chord length:
After the system calculates the combined resistance parameter,Given G02, G03 proposed synthesis and decomposition micro segment, This micro
multi-segment shaped scale is Chord length, This length can be set in the system, Reference value (0.1mm-5mm),
Note: Due to system has prospective multi-micro multi-line interpolation calculation, and therefore Chord length is undesirable too short,when it is
necessary to be too short, and processing speed must be somewhat lowered! ! !
G17 (X, Y) coordinate plane (plane default) G18 (X, Z) coordinate plane G19 (Y, Z) coordinate plane G04 (pause, delay)
Format: G04P ..
Between the two blocks by inserting a G4 block, You can make the given time of interrupt the machining P suffix to be milliseconds, a minimum of
500ms + P *
Case: (delay 1 second) G0X0Y0
G1Z-1F1200 G1X20Y20 G04P1000 G1X40Y40 G0Z5 G0X0Y0
G90 (default): Absolute dimensions G91: Incremental dimension
G90 and G91 commands corresponding to the absolute position data input and incremental position data input. G90 represents the coordinate
dimension of coordinates target point, G91 represents the displacement to be run.G90/G91 applies to all axes.These instructions do not decide to end
position trajectory, Trajectory is determined by the other G group G function commands (G0, G1, G2, G3 ...).After the program starts G90 applies to all
axes and remains active until later in the block have appeared G91.
Specific G commands G54 (coordinate system control) Format: G54P .. (coordinates irreversible, please carefully Operation) Coordinate system axes
are cleared the X-axis is cleared: G541 the Y-axis is cleared: G542 the Z-axis is cleared: G543
the A-axis is cleared: G544
