E-6
E-7
ProblEM
SolUtioN
Water mist and humidity
are not produced.
Power Plug: Unplug and then try again.
Power Failure: When the power is returned, try again.
Water Tank Installation: Make sure the water tank is
correctly attached. Make sure spring on tank
cap moves freely when pushed.
Air blows but water mist
is not produced.
Excessive Water: Remove water tank. Empty a small
amount of water from the base of the unit.
The desired humidity is lower than the current
temperature: Increase the desired humidity.
Detergent residue in the tank: Wash the tank out and try
again.
Humidity level is low.
The surface of the ultrasonic disk is dirty. Clean with
white vinegar.
The water in the unit is too cold: Replace with cool, but
not cold water.
If ultrasonic disk is damaged contact
customer Service at 1.866.603.5900.
Warm humidity is not produced.
It may take 10-15 minutes before warm humidity is cre-
ated. The mist may not feel warm to the touch.
Check to see if base of unit feels warm to the touch;
if so then warm mist is being produced.
The humidity has a bad smell.
Poor maintenance or dirty water: Clean the product
thoroughly, and fill it with fresh water.
White dust is forming on
nearby furniture.
Hard water will deposit a certain amount of dust. Dust
in the air settles because of the added humidity in the
room.
*Use distilled water if this becomes a nuisance.
Or order a
decalcification Filter (Fltdc20)
by calling 1.866.603.5900 or
visiting www.guardiantechnologies.com.
Light on front of unit is red.
Water tank needs to be refilled.
Tank won't align properly back onto
base of the unit.
Tank only fits on base in one direction. Try turning the
tank around until it fits securely in place.
Red/pink film or residue build-up on
or around the ultrasonic disk.
See cleaning instructions within manual.
Clean humidifier more frequently.
To the consumer, Guardian Technologies LLC warrants this product to be free of defects in
materials or workmanship commencing upon the date of the original purchase. Save your
original sales receipt to validate start of the warranty period.
If this product should become defective within the warranty period, we will repair or replace
any defective parts free of charge. The complete machine must be delivered pre-paid to the
authorized Guardian Technologies LLC warranty service center at the address below. Please
include complete information on the problem, date of purchase, copy of original sales receipt
and your name, address and telephone number. Call for assistance in the US or Canada at
1.866.603.5900. Use only genuine Guardian Technologies replacement parts.
The warranty does not include unusual wear, damage resulting from accident or
unreasonable use of the product. This warranty does not cover unauthorized repairs. This
warranty covers product that was purchased from an authorized distributor. This warranty
gives you specific legal rights and you may also have other rights (other rights may vary from
state to state in the U.S.A.).
We consider the registration process important to ensuring superior service to our
customers, however submitting the warranty card to Guardian Technologies LLC is optional
and does not affect your rights to utilize this warranty according to the conditions stated
above. If you have any questions or comments about our product call toll free at 1.866.603.5900
or send comments to:
this warranty can also be registered online at www.guardiantechnologies.com.
attN customer Service
Warranty Service center
Guardian technologies llc
7700 St clair avenue
Mentor, ohio 44060
Guardian technologies llc
7700 St Clair Avenue | Mentor, Ohio 44060
1.866.603.5900 | www.guardiantechnologies.com
©
2007 Guardian Technologies LLC
This product has been tested and complies with the requirements
for Federal Communications Commission, Part 18 for Radio/TV/
Communication interference. Although tested, it may affect these
devices. If the humidifier is found to interfere, separate the device
and/or the humidifier. Conduct only the user maintenance found in
this manual. Other maintenance and servicing can cause harmful
interference and can void the required FCC compliance.
