FITTING THE DECORATIVE FRAME
Heat Wave, New wave and Media models;
The appliance is supplied with a decorative frame. The frame attaches as a three piece clip-on assembly. If the firebox is to be retained by the
cable method, this is the most convenient stage at which to fit the three piece clip on
frame. Before fitting the frame remove any plastic protective coating. The side pieces
of the clip on assembly should be pushed into position first, followed by the top bar
(shown), which should overlap the sides.
IMPORTANT NOTE: Due to the possibility
of sharp edges, care should be taken when handling the three piece frame compo-
nents. The use of protective gloves is recommended. Place the firefront into position
in front of the fire and slide the ashpan door into place. Do not use any other firefront
other than the one supplied with this appliance. The firefront shown in these instruc-
tions may differ from the one supplied with the appliance.
Chloe, Juliet, Annabelle, Zara, Carmen, Carmen HIW and Churchill models;
The decorative frames must be fitted later - refer to section 13 of these instructions.
PREPARING THE OPENING
Before installing the fire, check the flue using a smoke pellet. All of the smoke should travel up the flue and exit correctly from the terminal.
If problems are found, DO NOT fit the fire until corrective action is completed.
Protect the decorative hearth whilst pushing the firebox in and out of the opening. Part of the packaging will make an ideal hearth saver pad.
Before running the gas supply into the opening, offer up the firebox to the fireplace
to check the fit is good. Angle the firebox or adjust the spigot outlet as described in
the Fitting the Firebox section. Ensure that it slides in correctly, the sealing face sits flat
and square to the wall or infill panel, and that the base is firm on the floor of the open-
ing as no leaks are permissible here. At this stage it is essential to ensure that the spig-
ot outlet of the fire is not restricted in any way. Remove the firebox and take any nec-
essary measurements before making good and preparing for final installation.
Apply the self adhesive sealing strips to the back of the fireframe to give a continuous
seal.
CABLE FIXING. For fixing of the fire by the cable method, see the relevant section.
The cable fixing locations should be marked on the back of the opening and the holes
drilled. Fit the wallplugs and eyebolts supplied to these holes.
SCREW FIXING. For fixing by screw, mark and drill the fireframe or base, and the rel-
evant points in the opening or on the wall. Wallplugs will again be required. Pre-punched holes are not provided for this purpose to allow you
to choose the optimum positions.
GAS SUPPLY. Following preparation for the fixing method, the concealed gas supply, where required, can now be put into place. Refer to the
gas supply section for suggested pipe routes. The ends of the sleeving in which the gas pipe is run should be sealed. The ends of the 8mm
supply pipe should be temporarily sealed to prevent the ingress of debris during fixing.
GAS SUPPLY ROUTING
When the opening is ready for installation of the fire, the gas supply can be routed as shown in the diagram below. IMPORTANT - Wherever
a concealed connection is made a rubber grommet must be used to seal the firebox.
8.1
9.0
10.0
6
© 2009 Pure Glow Limited
Inlet restrictor elbow
Grommets
Fireplace opening
Firebox
Summary of Contents for ANNABELLE
Page 19: ......