2
3
3
SNAP &
LIGHT
POWER
JUMPER
LED SOFT
STRIP
+
-
+
-
3:
When using the Snap & Light power jumper with another soft strip, follow the steps on Section One; steps 1 and 2 on
Section Two.
D
6:
Carefully remove the backing from the LED soft strip, make
sure not to remove the tape from the soft strip. Firmly press
down the adhesive portion of the soft strip onto the
mounting surface while removing the rest of the backing,
making sure there are no air bubbles that can cause surface
irregularities.
F
PAPER BACKING
HEAT SINK TAPE
6
4:
Clean the surface thoroughly where the LED strip will be
installed.
5:
Remove the backing from the Aluminum Heat Sink Tape and
firmly press down onto the surface where the LED strip will
be mounted.
E
NOTE
:
SS10C must use Heat Sink Tape. Omit step 5 if using
SS5C.
NOTE
:
The soft strip LEDs are rated for 40,000 hours when
using the aluminum heat sink tape.
NOTE:
The adhesive tape of the aluminum heat sink needs to
be affixed to smooth, clean surfaces (2" minimum). The tape
adhesive does not work well with porous, textured, or unfinished
wood surfaces. For these surfaces, soft strip clips are required
(sold separately).
5
PAPER
BACKING
SURFACE
ALUMINUM HEAT
SINK TAPE (SS-HR-F)
G
LED SOFT STRIP
POWER
SUPPLY
7:
Trim the other end of the Snap & Light connector when it is
used as the power cord. Refer to the wiring diagrams and
the instructions provided with the power supply to complete
the installation.
HEAT SINK TAPE
NOTE
:
SS10C soft strip consumes on average 9.6 Watt per
foot/ 5 Watt per color per foot.
7
NOTE
:
SS5C soft strip consumes on average 5 Watt per foot/
2.5 Watt per color per foot.
NOTE
:
Use Aluminum Heat Sink Tape to extend potential LED
life expectancy.
