Relocating Soft Strip (Optional)
IMPORTANT INFORMATION REGARDING INSTALLATION AND REWORK OF SOFT STRIP LED
3
DO NOT
use any tool to install soft
strip to a surface. This will damage the soft
strip component.
DO
only ever use fingers to gently install
soft strip to a surface
AFTER
cleaning the
surface with alcohol.
DO NOT
pull the strip
back towards itself. Doing so
risks damaging the strip and
making it not function.
DO
gently pull up and away
from the soft strip if removing
to reposition. This avoids
damaging the strip.
ADHESIVE BACKING
ADHESIVE
BACK SIDE OF SOFT STRIP
2
ADHESIVE TAPE
APPLY ADHESIVE REMOVER
AND THEN BUFF OFF
1
SOFT STRIP
REMOVE SOFT STRIP
TO RELOCATE
ADHESIVE TAPE
+24VDC
+24VDC
+24VDC
H
NOTE:
If relocating the installed soft strip, make sure that the
adhesive tape on back of the soft strip covers the entire strip.
The adhesive tape isolates the strip from the installation surface.
Damaged or inconsistent adhesive tape may cause the contacts
on the back of the strip to come in contact with the conductive
heat sink which will cause the strip to short and burn. Call Edge
Lighting to get replacement adhesive tape and/or optional
aluminum heat sink tape (SS-HR-F).
1:
To remove tape residue from back of the strip, apply WD-40,
Goo Gone, or a mixture of warm water and lemon oil to the
corner of a clean, dry towel. Gently buff the area containing
the adhesive residue until it is completely removed.
2:
Gently remove a few inches from one side of the tape
backing. Attach the adhesive tape to the back of the soft
strip and apply moderate pressure to affix the tape.
Continue this step a few inches at a time until the entire
adhesive tape is attached to the back of the soft strip.
3:
Refer to Section Two to reinstall the soft strip.
