4
2MM ALLEN
WRENCH
13
CONNECTOR
ASSEMBLY
COAXIAL
CABLE
M4 SET
SCREW
13:
Use the provided 2mm Allen wrench to securely tighten the
M4 set screw until it squeezes the wire ferrule tightly to the
coaxial cable.
K
14:
Replace the coaxial connector cover and tighten into
place.
L
14
COAXIAL
CONNECTOR
COVER
COAXIAL
CABLE
NOTE:
Ensure remote power supply wires are present in the
junction box. Refer to instructions provided with the power
supply.
NOTE:
If using 2" Round or Square Canopy, refer to the
instructions provided with the canopy to install the junction box
with 2" plaster ring.
For 4" Canopy:
15:
Feed the low voltage wires from the power supply through
the crossbar center hole.
16:
Mount the crossbar to the junction box holes with two
#8-32 screws.
M
15
#8-32
SCREW
16
CROSSBAR
JUNCTION
BOX
For Both 2" Canopy and 4" Canopy:
17:
Connect the red wire of the coaxial connector to the +24VDC power supply wire with a wire nut.
18:
Connect the black wire of the coaxial connector to the -24VDC power supply wire with a wire nut.
19:
Place all connections inside the junction box.
N
17
18
18
17
19
19
JUNCTION
BOX
JUNCTION
BOX
COAXIAL
CONNECTOR
COAXIAL
CONNECTOR
2" CANOPY
4" CANOPY
