Pure Water PTSF-2510-10, Owner'S Manual

Page: 5 / 31

Tech Support: 1-888-989-7873
PURE WATER TREATMENT, INC.
Page 5
•
This installation guide gives a step by step, start to finish procedure for installing
PURE TECH 2500 systems using Fleck valves.
•
Your new system from the PURE WATER TREATMENT, INC. comes with an
owner/service manual, which, is enclosed along with these instructions, and will help
explain all necessary details required for successful installation and operation of your
system. Please refer to these instructions and the service manual supplied with your
system during installation and programming.
•
All steps provided herein are for typical installations only. If you require additional
plumbing to install your system, simply contact a person who is knowledgeable in
residential plumbing or have a local plumbing company help you install, or install the
system for you.
•
There is a bit of "over-kill" in our instructions, but please bear with us as we want to
ensure that you, our customer, fully understand the instructions and are completely
satisfied with your installation!
•
We recommend that you take a few minutes and look at the service/parts manual for
your particular model, to help you better understand your new water system. Take
your time and carefully read the instructions.
•
Get all of your plumbing parts together before you start, and have an assistant help
you, if possible. Typical installation should take no more than a few of hours.
•
If you are going to turn the water off to your house while installing the system, we
recommend that you turn off the electricity to your electric water heater during instal-
lation. After the system is installed with water running through it, turn on a few hot
and cold-water faucets, and let them run until there is no more air in your lines, then
turn the electricity back on to your water heater.
•
Our systems can safely handle a pressure range of 35-95 psi. However, as with most
residential plumbing and for best operation causing the least wear on critical parts, we
recommend an operating range of 40-65psi. Now all you have to do is plumb in the
system, plug it in and set the current time of day!
System Overview