Pure Water PTSF-2510-10, Owner'S Manual

Page: 10 / 31

Tech Support: 1-888-989-7873
PURE WATER TREATMENT, INC.
Page 10
1. INSTRUCTIONS FOR USING A BYPASS VALVE. If you are using a bypass
valve, make sure your bypass valve is now in the "BYPASS" position.
2. Turn your water on slowly, leaving all your faucets in the house open until water
starts coming out of them. After they are all running steady and the air is out of the
water lines, turn them off one by one. The raw water will be bypassing your system at
this time.
3. Slowly open your bypass valve to the “SERVICE” position and begin filling the sys-
tem with water. In a few minutes the sound of water entering the system will stop.
4. Next, open one faucet, (preferably an outside faucet, a laundry sink or bathtub), let-
ting the water run through it slowly for a few minutes. This allows the water to rinse
the inside of your system out and settle the media.
5. Sometimes you may experience some light/medium brown or black color rinsing off
the new media..... This is normal...and should only last a few minutes.
6. This is why we suggest running the water through only one faucet, to clear the system
of this colored water.
7. After a few minutes, and the water is running clear.....turn the faucet off.
8. You now have clean water on your cold water side.... The hot water will take a couple
of days to become clean, as your hot water tank is full of bad water.
Turning the Water Back On