will need to reuse the fittings. Push in on the grey ring in the fitting, while pulling
the tube out with the other hand.
3.
Remove the fittings from each end of the post
filter (see figure 5). Wrap the threads of each
fitting with new Teflon tape, and install in the new
filter cartridge. Tighten securely.
4.
Connect the inlet side of the filter to the water-
line.
5.
Using a bucket, hold the filter outlet over the
bucket. Turn the main power switch to “On” and
allow water to flush the carbon fines out of the
new filter. If the storage tank is low, depress the pump switch to “Override” to flush
the filter.
6.
Once flushed, turn the main power switch to “Off”.
7.
Reconnect the outlet side of the filter to the waterline and turn the main power
switch to “On”.
page 16
Mega-Classic Owners Manual
Figure 5
