ASSEMBLY INSTRUCTIONS
Step 1.
Detach the X-Bike from the Shipping Frame.
Remove 2x Nuts securing the bike base to the
shipping frame. Detach the Bike Main Frame (1). Set
aside the Shipping Frame (67) until after assembly is
complete. Do not discard.
Insert the Lock Pin (13) to the lower front leg of the
Bike Main Frame (1) as shown.
NEVER
operate the bike without the Lock Pin
securely in place. Only remove this part when folding
the bike for storage, and keep it in a safe place.
Keep the Lock Pin in place during assembly to
prevent accidental folding of the X-bike.
Step 2.
Install the Front and Rear Stabilizers.
Attach the Rear Stabilizer (3) (without wheels) to the
Bike Main Frame (1), using 2x Bolt M10x60 (21), 2x
Arc Washers Large (40), 2x Spring Washers (41),
and 2x Safety Nuts (30). Make sure to insert the bolts
without any washers through the holes in the bottom
of the stabilizer, then attach 1st washer: Arc Washer,
2nd Washer: Spring Washer, and finish with the
Safety Nut.
Repeat the above steps for the Front Stabilzer (with
wheels).
Step 3.
Attach Seat and Seat Post to the Bike Main
Frame.
Attach the Seat (65) to the Seat Post (6) with 3x
Washers (35) and 3x Nuts (31).
Insert the Seat Post into the Bike Main Frame (1).
Make sure the adjustment holes in the Seat Post are
facing the rear of the bike. Line up the holes and se-
cure the seat with the Lock Knob (51).
