Punktal PK-C212, Instruction Manual

Page: 16 / 20

19
Tip: It is recommended to use semi-skimmed milk at refrigerator temperature (not
hot).
Note:
In choosing the size of your jug, it is recommended for the mug to be tall and
narrow. Also, keep in mind that the milk doubles the volume, so make sure the height
of jug is enough to allow for the increase.
5. Insert the frothing device into the milk about 2 cm (¾ inch).
6. As you turn the steam control knob slowly counterclockwise; the steam will come
out from the frothing wand. As you froth the milk, move the jug around and up-to-
down slightly.
Caution: Never turn the steam control knob rapidly, as the steam will accumulate
rapidly in short time, which can cause a risk of explosion.
7. When the desired amount of froth is reached, turn the steam control knob to the
minimum position.
Note: The steam wand and froth attachment should always be cleaned immediately
after frothing milk, to prevent the milk deposits from blocking the steam pipe and
nozzle. Remove the froth attachment, rinse it under warm water and wipe the steam
wand with a wet sponge.
8. Pour the frothed milk on top of each prepared espresso to you’re your cappuccino.
Sweeten to taste and, if desired, sprinkle the froth with a little cocoa powder.
9. Turn the steam switch and the ON/OFF switch to the “O” position and unplug the
coffeemaker
Note: After using the steam function, we recommend you allow the coffeemaker to
cool down at least for 5 minutes before making coffee again.
If not, a burnt aroma may occur in the espresso coffee made while the machine is still
not.
PRODUCING STEAM TO HEAT LIQUIDS OR FROTH MILK
Tip:
The steam wand can be used to make hot beverages like hot chocolate, water or
tea.
1. Open the water tank cover, remove the removable tank and fill it with desired
amount water.
Note: The water level should not exceed the “MAX” mark in the tank.
2. Place the tank firmly back in place and replace the tank cover.
3. Plug in the coffeemaker
4. Turn the ON/OFF switch to the “I” position; the red power light turns on.
5. Turn the steam switch to the “I” position and allow the heat until the green ready
light turns on.
6. Dip the steam wand into the liquid to be heated or the prepared frothing milk. Turn
the steam control knob slowly counterclockwise to start making steam.
7. When the required temperature is reached or the frothing milk is obtained, you can
turn the steam control knob to the minimum position.
8. Turn the steam switch and the ON/OFF switch to the “O” position and unplug the
coffeemaker.
Care and Cleaning
ENGLISH