5
INFORMATION ABOUT USE OF THE CHIMNEY HOOD
Section 6-1
LCD-Switch Chimney Hood Control Card Features
A
ON-OFF BUTTON
B
MINUS BUTTON
C
PLUS BUTTON
D
TIMER BUTTON
E
BULB BUTTON
F
ALARM BUTTON
On/Off Button:
used to start and stop the motor. In the beginning, the motor runs in 2
nd
cycle. The number
of cycle is represented by bar levels and the rotation speed of the fan shown at the left-side of the display.
Minus Button:
the cycle of motor reduces until it reaches 1
st
cycle each time when it is pushed if the motor is
running. In addition, it is used to reduce the timer value. On the display, it is represented by the number of bars
and the number of rotation of the fan.
Plus Button:
used to increase the cycle of motor each time when it is pushed until it reaches the highest
cycle level if the motor is running. In addition, it is used to reduce the timer value. On the display, it is represented
by the number of bars and the number of rotation of the fan.
Shutdown Timer Button:
a 15 minute starting timer value will be displayed and the clock icon will flash for 5 times
when this button is pushed while the motor is running. The clock icon will be displayed until the timer value lapses.
The motor will stop and the bulb will turn off, if it is on, when the timer lapsed.
Alarm Timer Button:
a 5 minute alarm timer will be displayed as starting timer on the display and the bell
icon will flash for 5 times when this button is pushed independent of whether or not the motor is running. The bell
icon will be displayed on the display until the timer time lapses. The buzzer will ring for 20 seconds and the bell icon
will flash when the timer lapsed. The buzzer can be shut by pushing the alarm timer when it is ringing.
Being valid for both of them; the timer value can be adjusted to any valu
e in
-between of 1 minute and 9 hour 59
minutes by pushing MINUS or PLUS buttons while flashing. The timer value will increase or decrease very quickly
when the MINUS or PLUS buttons are held pushed. The current value of the timer will be displayed on the d
isplay
when the timer button is pushed while the timer is set. The started timer button is pushed one more time and it will
be reduced until the timer becomes zero by pushing MINUS button if the started timer is needed to be cancelled.
Bulb Button:
used to turn on and off the bulb. The bulb will appear at the right-side of the display while it is on.
Filter Warning:
the (CLEAN FILTER) message which expresses that the filter should be cleaned will appear on the
display when the motor runs for 60 hours. The beep sound will be heard and the (CLEAN FILTER) message will
appear for 1,5 seconds more when the M.on/off button is held pressed for 4 seconds.
Power On:
the clock which is valid when the power failure occurred will be brought on the power on, and the operation
will continue in clock adjusting mode.
