9
Installation Step 2.
You will use:
① This is the toilet water tank, located
in the back of the toilet, the first water
valve closed, then the angle valve
preparation hose removed, the three
links and angle valve connection.
④ Connect the "water pipe" to the inlet
of the toilet bowl.
② And then the other end of the water
pipe connected to the three-way water
hole to complete!
③ Place the disassembled hose at the
other end with the tee, tighten with a
wrench.
1. When the inlet pipe is installed,
remember to turn the corner back on.
2. After the toilet cover body and inlet pipe
are installed, please take water first - after
power. 3. To remove the main body,
please close the angle valve and then
remove the power, and then reverse the
steps of the water pipe can be operated.
Explain：
This step is to allow the toilet to turn on
the water to prepare the front, like the
tap water half to the microcomputer
toilet! So that there will be covered with
clean water.
Connect the water pipe to open the
angle valve in case of new nozzle
nozzle, please plug in the power supply
it will automatically reset the nozzle will
stop the water.
Tips：
Please pay attention when
the main body and the water
pipe are installed
