Pulsar SLUDGE FINDER 2, Instruction Manual

Page: 103 / 140

Page 97
The third parameter for each relay determines the alarm ID for the relay you
wish to set.
P212, P222, P232, P242, P252, P262 - Relay Alarm ID
When P211, 221, 231, 241, 251, 261 = 3 (Loss of Echo), 4 (Loss of Clock), 5 (Wiper
Fault), 6 (Hi – Floc Alarm) or 7 (Service Interval Alarm)
This parameter has no function and will not be displayed.
P211, 221, 231, 241, 251, 261 = 1 (Level) or 2 (Temperature)
This parameter defines which alarm type the relay should respond to, as follows:
Alarm ID Description Setpoints
1=General (Default)
Relay goes “ON” when
the value reaches the ON
setpoint and goes “OFF”
when the value reaches
the OFF setpoint.
P2 1 3, 2 2 3, 2 3 3,
2 4 3, 2 5 3, 2 6 3 is
ON Setpoint;
P2
1 4, 2 2 4, 2 3 4,
2 4 4, 2 5 4, 2 6 4 is
OFF Setpoint.
2= High
Relay goes “ON” when
the value rises to the ON
setpoint and goes “OFF”
when the value lowers to
the OFF setpoint.
ON> OFF
Relay Setpoints
P2
1 3, 2 2 3, 2 3 3,
2 4 3, 2 5 3, 2 6 3 and
P2 1 4, 2 2 4, 2 3 4,
2 4 4, 2 5 4, 2 6 4
Setpoints, can be
set in any order as
the unit ‘knows’
that you are setting
a high level alarm.
3= Hi-Hi Same as 2 = High, but
different identifier.
4= Low
Relay goes “ON” when
the value lowers to the
ON setpoint and goes
“OFF” when the value
rises to the OFF setpoint.
ON<OFF Relay
Setpoints
P2
1 3, 2 2 3, 2 3 3,
2 4 3, 2 5 3, 2 6 3 and
P2 1 4, 2 2 4, 2 3 4,
2 4 4, 2 5 4, 2 6 4.
Setpoints, can be
set in any order as
the unit ‘knows’
that you are setting
a low level alarm.