www.pulsar.pl
INTRW
20
Setting the parameters of the serial port.
The settings describes in this subsection are to be applied to both RS485-WiFi interfaces. Select the ‘Basic
Serial Settings’ tab at the bottom of the window and adjust the settings as shown in the window below:
Fig. 23. Setting the parameters of the serial port communication.
Approve the settings with the ‘Apply’ button.
Next, select the ‘Advanced Serial Settings’ tab at the bottom of the window and adjust the settings in the ‘TCP
Settings’ section accordingly to the picture below. Approve the changes with the ‘Apply’ button.
Fig. 24. Configuration of communication parameters of the serial port – ‘TCP Settings’ tab.
Reset the RS485-WiFi interface by pressing the
‘
RST’ button on the module or by cutting off the power for
a few seconds. After the reset, the connection between the interface and the router should be re-established within
approx. 30s.
