Pulsar Forward FN135, Instruction Manual

Page: 8 / 84

Compatibility chart of inserts for the day devices
Outer diameter of day
device's lens, mm
Remove the cover (16) from the Cover Ring Adapter (19) by turning it
counterclockwise.
Put the insert (18) into the adapter, unsnap the clamp (22) of the
adapter (19) and firmly mount the adapter on the device's bell (17) to
ensure that the surface in the bottom part of the adapter is located
above the barrel.
Before installing it is advised to degrease the device's bell.
Install firmly the insert
(18) into the adapter (19) (Pic.3) .
Install firmly the adapter with insert onto the lens of your day device
(Pic.3) .
Snap the lever (22) from the original OPEN position to the CLOSE
position (Pic.3) .
10 9
Check that the adapter firmly fits the objective lens.
If you see there is a clearance, please:
- Loosen the locking screw
(20) with the hex-nut wrench (S=2mm).
- Tighten the screw (21) with hex-nut wrench (S=4mm).
Recommended clamping force is 1 N·m (can be checked with the
help of a torque screwdriver).
- Tighten the locking screw
(20) .
Insert firmly the device into the adapter so that the teeth in the
adapter's body enter the notches of the device. Turn the device
clockwise against the stop. Triangle-shaped marking on the device
and the square-shaped marking on the adapter should match.
To align the attachment, move the lever
(22) to the OPEN position
and align horizontally.
Powering on and image setup
Remove the lens cover (1) by turning it counterclockwise.
Turn the unit on with a short press of the ON (9) button.
Image appears on the display in several seconds.
To obtain a crisp image of the icons on the display, rotate the dioptre
adjustment ring of your optical device. After this there is no need to
rotate the dioptre adjustment ring for distance or any other conditions.
To focus on the object being observed rotate the lens focusing
ring
(10) .
To set up display brightness and contrast, please refer to the QUICK
MENU FUNCTIONS section.
After use, hold down the
ON button to turn the unit off.
11
Enter the menu with a long press of the М (7) button. To toggle
between the main menu options, press the RIGHT (6) and LEFT (8)
buttons.
12
QUICK MENU FUNCTIONS
The quick menu allows setup of display brightness and contrast.