Pulsar dBi 10, Instruction Manual, Page: 42 / 55

DBI (HART) INSTRUCTION MANUAL
42
P601-P603 Vessel Dimensions
These three parameters are used to enter the dimension required to
calculate the volume. The dimensions required are as shown below and are
entered
Measurements Units ( P104 ).
VESSEL SHAPE P601 P602 P603
P600 = 0
Cylindrical flat base
Cylinder
Diameter
Not required Not required
P600 = 1
Rectangular flat base
Not required
Width of
rectangle
Breadth of
rectangle
P600 = 2
Cylindrical cone base
Height of
base
Width of
rectangle
Not required
P600 =3
Rectangular pyramid base
Height of
base
Width of
rectangle
Breadth of
rectangle
P600 = 4
Cylindrical parabola base
Height of
base
Cylinder
diameter
Not required
P600 = 5
Cylindrical half sphere base
Cylinder
diameter
Not required Not required
P600 = 6
Cylindrical flat sloped base
Height of
base
Cylinder
diameter
Not required
P600 = 7
Rectangular flat sloped base
Height of
base
Width of
rectangle
Breadth of
rectangle
P600 = 8
Horizontal cylinder flat ends
Length of
cylinder
Cylinder
diameter
Not required
P600 = 9
Horizontal cylinder parabolic
ends
Length of
cylinder
Cylinder
diameter
Length of
one end
P600 = 10
Sphere
Sphere
diameter
Not required Not required
P604 Calculated Volume
This parameter displays the maximum volume that has been calculated by
the Ultra 5 and is a Read Only parameter. The volume displayed will be
shown in cubic meters and is the total volume available between
empty
level ( P105) and 100% of span ( P106 ).