Pulsafeeder Pulsalube 8 GS Ultra, Operation & Maintenance Manual

Page: 108 / 198

Blatt / sheet
Dokument / document
Ausgabe / issue
8 (9)
=876(XV
E / 21.05.2012
$X[LOLDU\HTXLSPHQW
'U\UXQQLQJSURWHFWLRQGHYLFH76(
([HFXWLRQ6WDQGDUG
'LVPDQWOLQJUHDVVHPEO\FRQQHFWLRQKHDGDQGWHPSHUDWXUHVHQVRU
¾ Adherence to associated drawing required.
'LVPDQWOLQJ
¾ Open cover of connection head.
¾ Remove connection wires at the temperature sensor.
¾ After loosening the screw at the side, pull off connection head from the threaded sleeve.
¾ Rotate threaded sleeve out of the stator.
¾ Remove clamp screw, rubber ring and temperature sensor from sensor sleeve.
5HDVVHPEO\
¾ Do not readjust the sensor sleeve installed at the factory.
¾ Install threaded sleeve in the stator.
¾ Install sensor sleeve.
¾ Open cover of connection head.
¾ Install connection wires at the temperature sensor.
¾ Remove protective tube (transport guard of sensor sleeve).
¾
Slide thermistor sensor with clamp screw and rubber ring up to the base of the sensor sleeve and
fixate.
¾ Screw threaded sleeve with two O-rings into threaded hole at the stator.
¾
When installing the connection head, route connection cable at the thermistor sensor from below through
the hole in the terminal board.
¾ After fixating the connection head on the threaded sleeve, fasten connection cable at existing terminals
and close connection head.
¾ Do not reuse sensor sleeve after dismantling.