64
ENT
ENT
ENT
ENT
= The page where tare tolerance value is entered. When entered in the
page by pressing the key, the value on the screen starts to flash and desired value is
entered via the keys and . Value is confirmed and saved by pressing the
key . How the parameter is used is illustrated with the basic application
examples below. This parameter cannot be equal or higher than the value
used in the mode
. Otherwise, device will alarm the error
.
.
= The page where material control belt is entered. Via the keys and
value is entered. Value is confirmed by pressing on the key .
.
= The page where material control time is entered. Via the keys and
value is entered as second (0.0-160.0). Value is confirmed by pressing on the key .
Note:
For checking material control belt and time as well as whether filling continued
or not during the filling process. When S1 or S2 outputs are active, if material at a
certain amount of H.bd is not put on scale within a period of
.
, device will close the
S1 and S2 output and will produce the error
. To enable this feature, values
other than 0 must be entered in parameters
.
and
.
.
.
= This page is just for information purposes. While filling in the mode
,
it shows how long the filling has been taken in seconds.
• A .0 = Active functioning duration of Tr-1
• b .0 = Active functioning duration of Tr-2
Note:
The vale entered in the automatic tare frequency (
) means the process
number. After production reached at the value entered, scale value is reset at the end
of time entered in parameterb
.
Device will not start within perion of
.
. For
absorbing of the vibration of the scale, the waiting time is
.
. If vibration is high
then parameter
.
value must be chosen higher, if low, then smaller.
