SuperRail Installation Inst. Rev. 2/23/2003 Page 23
1
Referring to figure 5 on this page figure 5 on page 22, install the Rear Mounting
Brackets P/N: 085403 and 085404. When fastening the Rear Mounting Bracket rear
hole location, make sure that the Frame Shim P/N: 33180701 is installed so that it
does not extend past the side wall of the frame. This will insure that the 5/8”-11 x 4
½” Bolt will fasten the Rear Mounting Bracket tightly to the frame. If the Frame
Shim
does
extend past the side wall of the frame, it is either made too long or it is
not seated properly against the Mounting Bracket through the opposite obround
hole. Finger tighten the 5/8”-11 Hex Nut and 5/8” Split Lock Washer.
2
To fasten the Rear Mounting Bracket front hole location, find the obround hole lo-
cated in the bottom of the frame rail just below and slightly behind the cross sill lo-
cated just ahead of the Rear Mounting Bracket position. Referring to figures 5 and
6, fasten the Rear Mounting Bracket at this location using the ½”-13 x 7 ½” Bolt,
Center Hole Back Up Plate P/N: 05070302 and 1/2” Lock Washer (nut is welded to
the bracket). Finger tighten only.
3 Return to pages 5 & 6 steps 4 through 12 to complete installation of hitch.
4 Torque all bolts per Torque Table specifications located on page 6
Dodge 2003, 3/4 & 1 Ton 4 x 4
Fig. 6
