Pullman Holt MAGNETspray, Owner'S Manual

Page: 2 / 16

Operation Guide
To Operate:
1 Prepare the tank mix.
2 Connect the twinline hose to the front panel.
3 Connect the twinline hose to the liquid and air leaders on the
handgun. If using the plastic bottle, connect the grey hose of the
plastic bottle hose assembly instead of the solution hose of the
twinline hose to the liquid leader.
4 Plug the power cord into an appropriate receptacle. Turn on the
air compressor.
5 Engage the trigger and spray.
To clean the sprayer after operation:
1 Clean the exterior of the sprayer.
2 Clean the tank and/or the plastic bottles
3 Disconnect the twinline hose from the handgun air line and liquid
line leaders.
4 Disassemble and clean the liquid filter. Be careful not to lose the
flow disk
5 Unthread the quick connect plug from the handgun liquid line
leader. Use a 7/16” wrench on the plug and an 11/16” wrench on
the 1/8” NPT body.
6 Connect the quick connect plug to the grey hose of the twinline
hose.
7 Fill the tank with 2 gallons of clean water.
8 Turn on the air compressor to flush the line with 1.75 gallons of
water. Turn off the air compressor.
9 Disconnect the quick connect plug from the twinline hose. Re-
thread it into the handgun liquid line leader.
10 Reassemble the liquid filter.
11 Turn on the air compressor and engage the trigger to flush the
handgun lines with the remaining water. Check the nozzles for a
good spray pattern while flushing. Allow air to flow for 30 seconds
after the water has been sprayed.
12 Apply silicone spray or similar lubricating oil to all quick connect
fittings.
13 Record application in the Spray Log.