16
17
How to Turn Off the Analyzer
To turn off the analyzer, press both buttons (Enter and Next) at the same time for three
seconds. After three minutes of idle time (without a test strip or check strip inserted)
the analyzer will perform a 10 second count down and turn off. To stop shutdown, press
either button. You can also remove the batteries to turn off the analyzer.
Setting Language
The first time the analyzer is turned on, you will be required to set the language, date,
and time. The language menu consists of the following choices: English (ENGLISH),
Spanish (ESPAÑOL), Italian (ITALIANO), German (DEUTSCH), French (FRANÇAIS),
Portuguese (PORTUGSE), and Dutch (NEDERL).
Note:
Languages may vary based on analyzer version used.
How to Set the Language (First-Time Use)
1.
Turn on the analyzer by pressing either button (Enter or Next).
2.
The display will read LANGUAGE. Press Enter.
3.
ENGLISH will be displayed. Press Enter if English is desired.
4.
For other languages press Next until the desired language is displayed, then press
Enter. To set the date and time, proceed to
How to Set the Time
and
How to
Set the Date
sections.
How to Reset the Language
1.
Turn off the analyzer.
2.
Press and hold Enter down for approximately 5 seconds during the analyzer
power-up stage until LANGUAGE is displayed.
3.
Press Enter. Press Enter again to select English or press Next to scroll through the
language choices.
4.
Press Enter to select the desired language that is displayed.
How to Set the Time
1.
If the analyzer is off, press either button to turn on the analyzer. Wait for the
display to read either INSTALL MEMO CHIP (if a current MEMo Chip
is not installed)
or INSERT STRIP (if a current MEMo Chip is installed). Press Enter. The display will
read RUN TEST.
2.
Press Next until SETTINGS is displayed.
3.
Press Enter. Press Next until SET TIME is displayed.
4.
Press Enter and the clock format is displayed: 12/24 HR.
5.
Press Next to alternately display the 12 hour AM/PM clock or the 24 hour clock.
Press Enter to accept the displayed clock format. The display will read HOUR and
the numerical hour. If 12 hour clock was chosen, AM/PM appears in the upper right
hand corner of the display.
6.
Press Next to increment the hour.
7.
Press Enter to accept the displayed hour. The display will read MINUTE and the
numerical minute.
8.
Press Next to increment the minutes.
9.
Press Enter to accept the displayed minute. The display will read SET TIME. To set
the date, proceed to
How to Set the Date
.
10.
To exit, press Next until EXIT is displayed. Press Enter.
11.
Press Next to return the display to RUN TEST.
