26
27
How to Obtain a Blood Sample from
a Fingerstick
1.
Use either the middle or ring finger for fingersticking.
2.
Select the site to allow for convenient collection.
3.
Clean the finger. Be sure the finger is completely dry.
4.
Use a new sterile, disposable lancet to puncture the skin.
5.
Apply gentle pressure to the finger with lancet
and stick the finger left or right of center. See picture.
6.
Use cotton or gauze to wipe away first drop of blood
for each test strip used.
7.
Gently apply pressure (squeeze and release) to the
finger to produce a large drop of blood.
Note:
Avoid
milking the finger. This may cause tissue fluid dilution
or hemolysis and affect the accuracy of results.
8.
Hold the capillary tube just below the bulb and
level with the angle of the finger.
Note:
Do NOT
squeeze the bulb of the capillary tube during collection
if applicable.
9.
Place the tip just touching the drop of blood allowing
the capillary action to draw the blood into the capillary tube
until sample reaches the fill line.
10.
Follow the specific instructions found in the test strip package insert for each
test for sample application and volume ranges. Use of a capillary pipet or blood
collector ensures a sufficient volume of blood has been applied to the test strip
11.
Make sure the test strip is inserted all the way into the test strip slot.
12.
Use the test strip and lancet one time only.
Dispose of properly.
Quick Reference - How to Run a Test
1.
Press either button to turn the analyzer on.
2.
Remove the MEMo Chip from the box of test strips.
3.
Insert the MEMo Chip in the port at the top of the
analyzer with the lot code number facing down.
4.
When INSERT STRIP is displayed, remove a test strip
from the vial and immediately replace the cap.
5.
Insert the strip. Ensure that the test strip is inserted
fully and the display reads APPLY SAMPLE.
6.
Obtain a blood drop following the correct technique.
(Immediately collect sample with capillary tube or
precision pipet and dispense correct volume* as
specified in test strip instructions for use (package
insert) on to the test strip.)
7.
Hold the capillary tube by the bulb and position above
the blood application window on the test strip. Use
care to avoid touching the test strip with the capillary
tube. Squeeze the bulb gently to deposit the entire
sample on the strip.
8.
Once the sample is applied, results will appear on the
analyzer display in as little as 45 seconds depending
on type of test strip.
9.
Remove test strip and
dispose of properly.
Each test strip is for a single test only. Do not reuse the
test strips. Use a new test strip each time you test.
10.
If the analyzer is idle for more than 3 minutes, it will
count down 10 seconds and automatically turn off.
CHOL
mg/dL
215
* Refer to each specific test strip package insert for sample volume and sample
application instructions.
