SIDE FOLD WALL MOUNT
14
Because the height adjuster mounting varies with the type of board, and the board to height adjuster
mounting varies as well, specific instructions for mounting both the height adjuster and the board are
supplied with the mounting kits.
The illustration below is for reference only and may not be the exact representation of the board or
wall mount in your application. Please refer to the specific instructions supplied with the MTG KIT,
HEIGHT ADJUSTER TO WM, and the MTG KIT BACKBOARD TO HEIGHT ADJUSTER.
Once the height adjuster and backboard
has been installed, final adjustments
to the FOB and chain tension can be
made.
Check to make sure each side of the
frame is still square to the wall.
Measure the distance from the wall to
the face of the back board on each side.
Loosen the set screws in the outer tubes
and slide the inner extension arm in or
out until the correct face of bank
(FOB) is reached. Once both sides of
the backboard are at the correct FOB
and the frame is still square to the wall,
tighten the set screws. Also tighten the
eyebolt on the slide tube.
Install the locking bolts on the
extension arms the prevent movement
of the arms.
Drill a 7/16” hole through the
inner extension tube using the
hole in the outer tube as a guide.
Install the 3/8” bolt (Item 28),
locknut (Item 30) and tighten
securely.
Repeat the process on all four extension tubes.
Install the play position stop (muffler
clamp) onto the inner slide tube.
Adjust the position of the clamp to make
sure the U-Bolt is under the indent of the
spring arm on the locking clamp.
Tighten the muffler clamp securely.
