3. Installation
1. Route the scanner/imager flex cable from the end-cap through the hole in the top of the back cover.
2. Fit the end-cap in place on the top of the hand-held, and use a T10 Torx screwdriver to tighten the four screws to a
torque of 5 in-lb (0.56 N-m).
If you are installing the standard end-cap without any data capture device (kit ST9301), proceed to step 11 to complete the
procedure.
3. If a scanner/imager flex cable is present in the end-cap, install the cable in socket J13 on the main logic board as
shown in Figure 2. If no cable has previously been installed in this socket, there may be a piece of “dummy” stiffener
material present in the socket, which must be removed before inserting the cable.
Figure 2
4. If a camera is installed in the back cover, repeat the instructions in step 3 to secure the camera flex cable in socket
J9 of the main logic board.
5. Insert the pistol grip trigger/speaker wire harness in the white socket on the left side of the main logic board.
6. Fit the back cover in place against the main housing, ensuring that no cables are caught in the seal. If a pod flex
cable is installed, ensure that the free end can be accessed through the pod opening in the back cover.
7. Use a Torx T10 screwdriver to tighten the eight screws (M3x6 mm) to a torque of 5 in-lb (0.56 N-m). Install the
screws in the sequence shown in Figure 1
on the previous page to ensure a consistent seal around the opening.
8. Using a Torx T6 screwdriver, replace the two screws (M2x8 mm) above the display on the front of the unit. Torque
to 2.5 in-lb (0.28 N-m).
9. If you are reattaching a pod, connect the flex cable to the pod.
10. Reattach the pod or blanking plate using a Torx T10 screwdriver and four screws (M3x5 mm).
11. Install the battery.
Back cover
End-cap
Scanner/Imager Flex Cable
Flip latch open
Flip latch closed
Insert cable
COMPANY HEADQUARTERS
SUPPORT SERVICES
Psion Inc.
For local support services, go to:
2100 Meadowvale Boulevard, Mississauga
http://www.psion.com/service-and-support.htm
Ontario, Canada L5N 7J9
Tel:
+1 905 813 9900
Fax:
+1 905 812 6300
