PSC SP400rf, Programming Manual

Page: 37 / 112

R44-1027
31
L
ABEL
T
RANSMIT
F
ORMAT
C
ONFIG
S
ETTING
A S
INGLE
C
HARACTER
P
REFIX OR
S
UFFIX
To set one ASCII character as a prefix or suffix, follow steps one through
four on the previous two pages (select prefix or suffix), then...
1. Scan the two digit Hex Code for that character.
(e.g. 03, 8F, ...FF)
NOTE
If you make a mistake, or lose your place while setting this option,
scan the “end” label to exit Programming Mode. The scanner will
sound a rejection tone (a “good beep” followed by a low “bad
beep”) to indicate that programming was incomplete, and the
setting will remain as it was before entering Programming Mode.
2. Scan the One Character Only label on the following page.
3. Scan the END label.
You have set a single character prefix or suffix.
S
ETTING
P
REFIX AND
/
OR
S
UFFIX
C
HARACTERS
NOTE
You must scan the SET label and either the
Set Prefix or Set Suffix label before using the
labels on this page.
0 -----------------------------
1 -----------------------------
2 -----------------------------
3 -----------------------------
4 -----------------------------