R44-1027
29
L
ABEL
T
RANSMIT
F
ORMAT
C
ONFIG
S
ETTING
N
ON
-S
YMBOLOGY
S
PECIFIC
P
REFIX
(
ES
)
These characters will be added to the standard label format when your
host system has specific and unique requirements for information added
to the barcode label data before it is sent to the host. Identify your
specific system requirements before adding or modifying these settings,
then...
1.
Look at the ASCII chart shown on page 33 and identify the
ASCII character(s) and the corresponding Hex Code(s) for the
ASCII characters you will use as prefixes.
For example, if you are going to send two prefix characters
as 'STX' (start transmit) and 'SP' (Space). The ASCII chart
shows that 'STX' equals 02
hex
and 'SP' equals 20
hex
.
2.
Scan the SET label.
3.
Scan the SET PREFIX label on this page.
4.
Scan the digits that correspond to the Hex Values.
For the example in step four, scan 0, 2, 2, 0.
NOTE
If you make a mistake, or lose your place while setting this option,
scan the “end” label to exit Programming Mode. The scanner will
sound a rejection tone (a “good beep” followed by a low “bad
beep”) to indicate that programming was incomplete, and the
setting will remain as it was before entering Programming Mode.
5.
Scan END.
You have added a two character prefix to all label data,
regardless of label symbology, that will be added to the
label data before it is sent to the host.
SET
-------------------------------------
S
ET
P
REFIX
-------------------
G
O
TO
THE
SECOND
PAGE
FOLLOWING
THIS
AND
SCAN
THE
APPROPRIATE
CHARACTERS
BEFORE
SCANNING
THE
END
LABEL
TO
EXIT
PROGRAMMING
SESSION
.
Summary of Contents for SP400rf
